|
 El módulo conductividad (item no.1003)
Just as all the other models are, the coductivity module
is suitable for both freshwater and seawater aquariums. In freshwater aquariums,
the conductivity is displayed in µS/cm. In the case of seawater aquariums
you can choose between having the conductivity displayed in mS/cm, the salt
content or the density! All measurements are relative to a reference temperature
of 25°C. In the section Tips and Tricks, you will find a table for the
conversion of conductivity into salt content and density.
Uso
  For
example, if conductivity is falling you can add salt-water, and if it is
increasing then distilled water or osmosis
water.
Datos técnicos
A
high-quality, low-maintenance sensor comprising 4 platinum electrodes
4-conductor
method for greatest precision
Measuring
range I from 10 µS to 1 mS, resolution 1 µS,
switch hysteresis 10 µS
Measuring
range II from 1 mS to 100 mS, resolution 0.1 mS, switch
hsteresis 0.2 mS
Automatisc
or manual temperature compensation
Automatic
calibration with sensor test
Up
to eight control process can be programmed
Upper
and lower alarm settings
1mS
und 50 mS calibration solutions included in the set
SUGERENCIA:
 En caso de alarma, mensaje de texto (SMS) a su móvil. De esta manera pueden evitarse daños mayores.
 vuelta a elección
|
